diff --git a/ont/ont-nokia-g-010s-p.md b/ont/ont-nokia-g-010s-p.md
index bbb44c52..1db6e1c5 100644
--- a/ont/ont-nokia-g-010s-p.md
+++ b/ont/ont-nokia-g-010s-p.md
@@ -284,10 +284,6 @@ The following commands are used to flash a new rootfs to image1 and then boot to
 Some OLTs don't like when ONTs don't boot from image 0, therefore the previous procedure must be preceded by the following procedure with inverted images, as to clone image 1 into image 0
 :::
 
-## Flashing a new rootfs via Serial
-
-If you wish to change the firmware via serial, we recommend using the web app: [Web Serial Flash](/ont-nokia-g-010s-p-ymodem)
-
 # TX Fault / Serial
 
 The stick stays in a perpetual "TX Fault" state since the same SFP pin is used for both serial and TX Fault signaling, if that causes you issues (normally it shouldn't) you can issue the commands below to disable it. Note that it will disable both the TX Fault signal and Serial on the stick after boot.